Operates with inputs from DC to 40kHz Conditions Tachometers, Turbines, Power, VFD's, others 5V logic pulse output equals input frequency Inputs from 20mV pk-pk to 250Vrms (700V pk-pk) Full isolation protects against ground loop & safety hazards Adjustable sensitivity, optional filtering Full Replacement Warranty

JH2376 PDF DATA SHEET

JH2376 PDF MANUAL

Model JH2376 pulse conditioner accepts a wide range of input voltages and waveforms and produces an isolated 5 volt logic pulse output at the same frequency. It may be used to isolate and condition signals ranging from millivolt-level magnetic pickups to 230Vac power frequencies. No calibration is needed - the output frequency automatically equals the input.

Two sets of input connections support a wide range of applications. The low input connection is optimized for sensors such as magnetic coil tachometer and turbine meter pickups, while high level applications such as power monitoring and variable frequency drives use the high input. (Use the high input for logic pulses.) Adjustable sensitivity, built-in hysteresis and optional filtering minimize interference from noise pickup. Applications range from turbine flow sensors and tachometers to power monitoring and other high voltage applications.

The one-inch-wide case snaps onto DIN rail. The terminal strip unplugs for ease of replacement. The JH2376 handles input frequencies from DC to 40kHz (0.2Hz minimum on high input). When used in high humidity or dirty environments, optional urethane circuit board coating is available.