JH5040 4/20mA INPUT TRANSMITTER
WITH LOOP EXCITATION SUPPLY
DIN-RAIL MOUNT
|
The Model JH5040 DIN-Rail Transmitter provides an isolated DC voltage or current output proportional to a 4/20mAdc input. Designed to isolate and convert signals from 2-wire (loop-powered) transmitters, it includes a regulated 24Vdc input loop supply. The input also may be configured for standard 4/20mA inputs, bypassing the 24V supply.
Other input ranges are possible. For example, the loop excitation supply might be used to power a "3-wire" style transmitter having 0/5V or 0/10Vdc output. Contact us with your requirements.
Red-green Quick-Check LEDs give a quick indication of the relative output. Red is brighter at the low end, green at high, while at mid-scale both are approximately equal. Red-only indicates offscale low while green-only indicates offscale high.
Available options include AC and DC power choices and reverse-acting transmitter (decreasing output with increasing input).
ORDERING INFORMATION
| Model Number: | Specify Model JH5040A for AC power, JH5040D for DC power.. |
| Input Range: | 4/20mAdc. Others available - contact factory. |
| Output Range: | Specify any DC voltage or current range allowed by the "Output Capabilities" spec, below. |
| Power: | Specify 115Vac, 230Vac, 12Vdc or 24Vdc. |
| Reverse-Acting Transmitter (decreasing output with increasing input): | Change model number to JH5041(A or D). |
| Loop-Powered Output: | 4/20mA "current sink" output stage for connection to devices whose inputs provide 24Vdc loop excitation. Change model number to JH5042(A or D). |
| Urethane Coating: | Specify Option U |
INSTALLATION AND CONNECTIONS
Model JH5040 snaps onto 35mm DIN rail. Connections are made to the front-panel terminals. The terminal strip unplugs to facilitate calibrating or replacing the transmitter.
Connections to the 8 terminals (top to bottom) are:
1: Input plus.
2: Input minus.
3: +24Vdc loop excitation.
4: No connection.
5: Output plus.
6: Output minus.
7: Power (AC or, if DC power option, DC plus).
8: Power (AC or, if DC power option, DC minus).
DETAILED SPECIFICATIONS
| Input: | 4/20mAdc. Others available - contact factory. |
| Input Loop Excitation Supply: | 24Vdc regulated. 25mA max. current. |
| Voltage Output Capabilities: | 1 volt minimum output span, -10 to +15V absolute limit. Offset ranges are allowed. Maximum output load, 10mA (1Kohm at 10V output). |
| Current Output Capabilities: | 1mA minimum output span, 0 to +25mA absolute limit. Positive offsets are allowed, negative outputs are not. Output drive capability, 24V (1,200 ohms max. at 20mA output). |
| Accuracy (factory calibration): | +/-0.1% of span. |
| Adjustability: | Zero and span each are adjustable approx. +/-15% of span. |
| Linearity: | +/-0.05% of span or better. |
| Response Time: | Under 100 milliseconds. |
| Isolation: | 3-way (Power/Input/Output) 1,500Vac rms (2,100V peak). |
| Guaranteed Operating Temperature: | -10 to +60 deg. C (14 to 140 deg. F). |
| Temperature Stability: | +/-0.02% of span per deg. C, or better. |
| Power Requirements: | AC, 115 or 230Vrms, 50/60Hz, 2.5V-A. DC, 12 or 24V, 2.5W. |